Jalie 2787

 

Here we are stash-busting with fabric AND pattern today. I’ve had this fabric and pattern in their respective stashes for a long time. The fabric is a tissue thin knit but surprisingly firm given how sheer it is. The only thing preventing this from being a see-through shirt is the ink of the print and the overlay design on the front. Definitely a cami is in order when wearing this top since there are no overlays on the back. I made my usual size T in Jalie knit tops and it is snug, but not unwearable. If I made it again I would size up if the knit was similar. For a stretchier knit, I would sew the size T again.

One comment on the design: the layer under the crossover portion is not stitched to anything at the top, this makes the design suitable for nursing, but I felt that the elastic that is stretched across the top of the piece before stitching it to the side seams could be a bit shorter to prevent possible sagging. I’m not convinced it’s going to hold up, but don’t want to risk tacking it to the under layer because I fear that would be unsightly.

Another comment on the instructions: they are not clear on step 6, figure 8, pre-sewing the partial side seams. Here is where you create the over/underlap and they make no mention of how it’s accomplished. It’s not hard, but neither is it obvious until you think about it. I had to pick out my first side seam attempt because I left a layer out. There are 3 layers going in to this partial side seam, the back, the underarm portion of one top front and the side (lower) portion of the OTHER top front. It’s not until the next step you finally add the bottom front, which is attached only at the side seams and then you can serge everything for a clean finish. They don’t say it, but you are basically basting the upper tops and then the front to the back with zig-zag stitching before making a final (optional, really) pass with the serger to clean finish everything. Here’s a picture of the front from the inside prior to the final pass with the serger, note that you can see more layers on the right side:

Jalie2787-1b

This is a first for me: I am going to leave this top un-hemmed. I can see why RTW is doing this more these days with the very lightweight knits. The fabric resists hemming, wanting to curl and puckering when stitched. I could fuss with the settings on my coverstitch machine in the hope of getting a more successful hem, but I really want to move on and am not sure how much I’m really going to wear this top, so I think I’ll just roll with it. Literally.